Ncore v1 Naked die cooling waterblock

Independent floating fixture

If you are not convinced with unique “no frame” solution of the V1, then this is another option.

All waterblocks on the market are using 4 screws standard installation bracket, however, to eliminate uneven stresses on the CPU core many company use springs.

For direct on die Ncore’s installation it was not enough, its special floating fixture uses hinge concept to eliminate stresses.

Water 20x closer to the CPU

All modern CPUs are trapped behind wall of metal (IHS), what is probably the biggest flaw in their design. By integrating the IHS with the Ncore’s, water is enabled to flow 20x closer to the CPU, when compared to other systems available on the market.

This is not an aerospace science, just basic physics. Less metal in-between heating and cooling source- equals better conductivity. The thickness of the isolator (which is IHS) is inversely proportional to thermal conductivity; it is like in your house over the winter- thinner the wall the colder inside

NAKED DIE COOLING

Designed for delidded CPU (F.I.T.W)

It is all about delidding- it is worth it!

The cooling surface of the Ncore is designed to cool the CPU die specifically, not the  IHS like the competition. This forced us to come up with completely redesigned cooling chamber.

True Adjustable water flow (F.I.T.W)

Each custom water-cooling system is unique, after all, it is custom. As miniaturization is the key to modern engineering, I have designed the Ncore to, not only perform great powered by high flow systems Di5 pump but to be adjusted and used in a low flow pressure system. For the first time, you will be able to adapt waterblock to your system

3D Watercooling (F.I.T.W)

Using Linear Stress Analysis, Nonlinear Analysis, Thermal Structural Analysis, Computational Fluid Dynamics (CFD) I was able to achieve an excellent performance of the Ncore with minimal waterflow resistance (which can be adjusted anyway)

Metal Inlet- Outlet thread 1/4

To prevent leaking, improve durability, strength and overall structural integrity of the Ncore it has a brass top, and a metal ¼ inlet- outlet connectors.

O-rings

The biggest risk in PC water-cooling is leakage. I decided to use the best components available in 21 century taken from an Aerospace, F1 an Oil industry- a Viton® or FKM rubber

Designed as delidding tool (F.I.T.W)

I believe that best design must be unique and innovative, that’s why I decided to try make delidding convenient for you, so the delidder is incorporated into the design of the Ncore V2 frame.